Pump Accessories

Batch Controllers

Batch controllers are available in two basic configurations. The Model B2 controller is engineered to provide control of the number of cycles produced by a solenoid-controlled AODD pump in a “Batch”. This handheld unit is locally controlled and programmed for individual batching and dispensing operations. The Model 420 controller is engineered to provide speed control of a solenoid-controlled pump that is linearly proportional to an external 4-20 ma signal. Both controllers should be used with our 12VDC solenoids.solenoids are available in 12VDC, 24VDC, 120VAC or 220VAC and utilize a standard DIN 43650B or DIN 43640C connector, depending on the pump size. In addition to solenoid control, cycle counters are available on all pumps.

Literature > Manual >

Drum Pump Kits

Drum pump kits allow for the convenient transfer of fluids from a 55 gallon drum. Each kits is make of compatible material and comes with a 40 inch tube (for maximum fluid transfer) and a bung adaptor (for connection to the drum. Drum Pump kits are available for all ¼ inch, 3/8 inch, ½ inch and 1 inch pumps.

Literature >

Filter/Regulator Guages

FRGs filter and regulate air pressure to control the speed of an AODD. Available in ¼ inch, ½ inch, & ¾ inch for use with all sizes of AODDs.

Literature >

Grounding Kits

Grounding Lugs are available for all sized pumps and should be used to comply with ATEX requirements.

Literature >

Pulsation Dampeners

In general a pulsation dampener is used when one or more of the following criteria are required: to prevent potential pipe vibration, to reduce the load on the pump to minimize or eliminate pulsation for spraying application or other downstream requirement. It works by means of an air cushion created by the pressure of the media pushing the diaphragm upward. This allows air to enter the chamber keeping the diaphragm center at midstroke. During operations the diaphragm flexes thus absorbing and equalizing the pressure surge. Properly sized and installed these dampeners provide evirtually surge-free discharge flow. Dampeners are available in connection sizes ranging from 3/8 inch to 3 inch and come in a range of materials and connections for compatibility with all of our pumps.

Literature > Manual >

Solenoid Adaptors & Electronic Options

In general solenoid control for All-Flo pumps are available in two types: on/off control and integrated pulse control for metering and dispensing applications. On/Off Control are available with air ports in both 3/8 inch and ¾ inch and thus can be used and an accessory on any available pump. Pulse control solenoids are factory installed in ¼ inch, 3/8 inch, ½ inch & 1 inch pumps and can be used for dispensing application with our B2 Batch Controller of integrated with a PLC. All solenoids are available in 12VDC, 24VDC, 120VAC or 220VAC and utilize a standard DIN 43650B or DIN 43640C connector, depending on the pump size. In addition to solenoid control, cycle counters are available on all pumps.

Literature >